Använd läsaren nedan för att läsa Atosa AEC-0711E ugn bruksanvisningen. Du kan bläddra genom bruksanvisningen direkt på sidan och använda vår läsares funktioner för att hitta all viktig information om installation, användning och underhåll av denna Atosa ugn.
Bruksanvisning
HelskärmFelkoder
Nedan hittar du felkoderna för Atosa AEC-0711E.
Oven chamber high temperature protection
Manually reset the HTCO switch
Oven fan motor high temperature protection
Wait until the fan motor cools down
Oven fan speed fault
Contact the manufacturer or authorized service center
Oven fan not working or fan speed sensor fault
Contact the manufacturer or authorized service center
Heating system fault
Contact the manufacturer or authorized service center
Low water pressure - no humidification or cleaning process can start
Increase the water pressure
Door is open for more than 2 hours or a magnetic switch fault
Close the door, and if it doesn't work, contact the manufacturer or authorized service center
Open circuit of trolley relay (only for oven with more than 16 trays)
Push the trolley into the oven
Felsökning
Praktiska tips för att lösa de vanligaste problemen med Atosa AEC-0711E.
Orsak: Power switch off, protecting fuses not working, or faulty safety thermostat
Check that the switch is turned on and there is power. Check that the oven protecting fuses are working properly. Check the safety thermostat. If none of these solutions work, contact an Authorized Service Center.
Orsak: Door not closed properly or parameters not correctly set
Check if the oven door is closed properly. Check if the parameters are correctly set.
Orsak: Cooking chamber overloaded, fans cannot work in reverse, or fans/resistances not working
Distribute the food to allow air circulation. If fans cannot work in reverse or one of the fans/resistances is not working, contact an Authorized Service Center.
Orsak: Water inlet closed, incorrect water connection, suspended water supply, or blocked water inlet filters
Open the water inlet. Check connection to the water mains or water supply. Clean or replace blocked water inlet filters.
Orsak: Dirty or damaged seal, faulty door closing mechanism, or loosened door handle
Clean the seal or contact an Authorized Service Center to replace it if damaged. Contact an Authorized Service Center to repair the door closing mechanism. Check and fix the door handle or contact an Authorized Service Center.
Orsak: Faulty fan
Contact an Authorized Service Center to replace the fan.
Vanliga Frågor
De vanligaste frågorna om Atosa AEC-0711E.
Hjälp
Har du frågor om ugn AEC-0711E från Atosa? Ställ dem direkt till vår expert! Du får information, praktiska tips och skräddarsydda lösningar på bara några sekunder.
Relaterade bruksanvisningar
Nedan hittar du bruksanvisningar för ugn som liknar AEC-0711E. Prova även att se alla Atosa ugn bruksanvisningar
Diskussion
Lämna en kommentar eller ställ en fråga
Delta i diskussionen
Ställ en fråga om bruksanvisningen eller lägg till ett användbart svar för andra användare.