Använd läsaren nedan för att läsa Philips ADD6928 vatten dispenser bruksanvisningen. Du kan bläddra genom bruksanvisningen direkt på sidan och använda vår läsares funktioner för att hitta all viktig information om installation, användning och underhåll av denna Philips vatten dispenser.
Bruksanvisning
HelskärmFelkoder
Nedan hittar du felkoderna för Philips ADD6928.
Unable to cool the water - If the machine is not dispensing cold water, or the cooling time exceeds 1 hour in a single cycle, the machine will activate its cooling protection and stop cooling
Power off for 1–2 minutes, then restart
Unable to dispense cold water - Cooling temperature sensor failure
Power off for 1–2 minutes, then restart
Unable to heat water - Tap water temperature sensor failure or tap water temperature > 100℉
Ensure tap water added to the tap water tank is below 100°F
Unable to dispense hot water - Temperature sensor at the spout outlet is malfunctioning
Dispense 3 cups of 150ml ambient temperature water, then retry hot water
Unable to dispense hot water - Heating failure detected
Dispense 3 cups of 150ml ambient temperature water, then retry hot water
Unable to filter and dispense water normally - Abnormal water filtration alarm. Filter not installed properly or clogged
Check if the filter is installed properly. If the filter is clogged, please replace it
Communication abnormality of the product - Abnormal communication signal within the product's electronic control board
Power off for 1–2 minutes, then restart
Felsökning
Praktiska tips för att lösa de vanligaste problemen med Philips ADD6928.
Orsak: Filtered water jug is empty
If flashing icon appears, wait for it to stop flashing before dispensing water
Orsak: Tap water tank installation error
Check tap water tank installation
Orsak: Low water level in tap water tank
Refill the tap water tank with clean water
Orsak: Drip tray overflow
Empty the drip tray
Orsak: Foreign objects lodged around the spring-loaded seal at the bottom of the tap water tank
Use a probe to check for any foreign objects lodged around the spring-loaded seal at the bottom of the product, and remove them if found
Orsak: Filtered water jug installation error
Ensure the filtered water jug is properly installed and securely seated with no gaps
Orsak: Failure to rinse as required during initial use or after filter replacement, or the appliance has not been used for an extended period
Refer to the New Filter Flushing section in this manual
Orsak: Filter requires replacement
Refer to the Filter Replacement section in this manual
Orsak: Improper grounding or damaged power cord
Use only a properly grounded three-prong outlet. If the power cord is damaged, contact customer service for a replacement
Orsak: System error or hardware damage
Power off for 1–2 minutes, then restart
Vanliga Frågor
De vanligaste frågorna om Philips ADD6928.
Hjälp
Har du frågor om vatten dispenser ADD6928 från Philips? Ställ dem direkt till vår expert! Du får information, praktiska tips och skräddarsydda lösningar på bara några sekunder.
Relaterade bruksanvisningar
Nedan hittar du bruksanvisningar för vatten dispenser som liknar ADD6928. Prova även att se alla Philips vatten dispenser bruksanvisningar
Diskussion
Lämna en kommentar eller ställ en fråga
Delta i diskussionen
Ställ en fråga om bruksanvisningen eller lägg till ett användbart svar för andra användare.